DeLonghi Cooking hob Instructions d'exploitation télécharger pdf (Page 27)

ASSEMBLY AND

DISMANTLING OF THE

SIDE RUNNER FRAMES

– Fit the side runner frames into the

holes on the side walls inside the

oven (Fig. 7.3).

– Slide the tray and rack into the run-

ners (Fig. 7.4).

The shelf must be fitted so that the

safety catch, which stops it sliding

out, faces the inside of the oven.

– To dismantle, operate in reverse

order.

Fig. 7.3

INSIDE OF OVEN

The oven should always be cleaned after

use when it has cooled down.

The cavity should be cleaned using a mild

detergent solution and warm water.

Suitable proprietary chemical cleaners

may be used after first consulting with

the manufacturers recommendations and

testing a small sample of the oven cavity.

Abrasive cleaning agents or scouring

pads/cloths should not be used on the

cavity surface.

• NOTE: The manufacturers of this appli-

ance will accept no responsibility for

damage caused by chemical or abra-

sive cleaning.

Attention: Do not store flamma-

ble material in the oven.

REPLACING THE OVEN LIGHT BULB

Switch the cooker off at the mains. When the oven is cool, unscrew and replace

the bulb with another one resistant to high temperatures (300°C), voltage 230 V

(50 Hz), E14

and same power (check watt power as stamped in the bulb itself) of the

replaced bulb.

Note: Oven bulb replacement is not covered by your guarantee.

Fig. 7.4

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Pas de commentaire

DeLonghi Cooking hob Instructions d'exploitation Page 27