DeLonghi Domino Spécifications télécharger pdf (Page 16)

LIGHTING GAS BURNERS (

WITHOUT SAFETY CUT-OFF VALVE)

To light one of the gas burners, push in and turn the relative knob to the maximum

aperture position (large flame symbol) and hold the knob in until the flame has been

lit.

The sparks produced by the ignitor situated near each burner will light the flame.

Whenever lighting any of the burners produces an abnormal flame, switch that burner

off and relight using the minimum setting.

LIGHTING GAS BURNERS (FITTED WITH SAFETY CUT-OFF VALVE)

In order to light the burner, you must:

1 – Turn the knob fig. 18 in anti-clockwise direction up to the maximum aperture,

push in and hold the knob; this will light the gas. If there is no mains electrical

supply, bring a lighted match close to the burner.

2 – Wait about ten seconds after the gaslights before releasing the knob (starting

time for the valve).

3 – Adjust the gas valve to the desired position.

If the burner flame should go out, the safety valve will automatically stop the gas

flow.

To re-light the burner, first turn the oven control knob to position l, wait for at least

1 minute and then repeat the lighting procedure.

If after relighting the burner, the flame is still abnormal, turn the burner off and

contact our Customer Service Centre to obtain the nearest authorized Delonghi Service

Agent.

GRILL FOR SMALL COOK-

WARE

(fig. 19)

Put it on the semi-rapid burner (the

smallest) grid when small cookware is

being used to prevent the cookware

from tipping over.

Figure 19

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

DeLonghi Domino Spécifications Page 16